Fr Map Ip - HP MSR series Command Reference Manual

Command
fr lmi type
Usage guidelines
LMI protocol maintains frame relay protocol PVC table, including notifying PVC increasing, detecting
PVC deleting, monitoring PVC status changing and authenticating link integrity. The system usually
supports three standard LMI protocols ITU-T Q.933 Appendix A, ANSI T1.617 Appendix D, and
nonstandard-compatible LMI protocol.
The bi-direction keyword specifies the interface to respond to Status-Enquiry messages form network side
when operating in frame relay DTE mode. It does not enable frame relay network specifications of the
network side and has no effect on frame relay DCE interfaces. This keyword is needed only when the
current device is to communicate with routers that require bi-directional LMI, such as Motorola Vanguard
5.3 or previous versions.
Examples
# Set the frame relay LMI type of Serial 2/0 to nonstandard compatible protocol.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] fr lmi type nonstandard

fr map ip

Use fr map ip to add an IP address map entry for frame relay.
Use undo fr map ip to remove an IP address map entry for frame relay.
Syntax
fr map ip { ip-address [ mask ] | default } dlci-number [ broadcast | [ ietf | nonstandard ] ] *
[ compression { frf9 | iphc connections number } ]
undo fr map ip { ip-address [ mask ] | default } dlci-number
Default
No static address map entry exists and InARP is enabled.
Views
Interface view
Default command level
2: System level
Parameters
ip-address: Peer IP address.
mask: Peer IP mask in the format of X.X.X.X, where X is an integer in the range of 0 to 255.
Parameter MSR 900
bi-direction No
MSR
MSR 93X
20-1X
Yes
(Supproted
by
JG514A, Yes
JG515A
and
JG531A)
127
MSR 20 MSR 30
Yes Yes
MSR 50
Yes