Display Bridge Traffic - HP MSR series Command Reference Manual

Bridge set 1 :
configure :bridge 1 enable;
interface :total 2 interface(s) in the set
Bridge set 2 :
configure :bridge 2 enable;
interface :total 2 interface(s) in the set
Table 62 Command output
Field
configure
interface
The output shows that bridge set 1 and bridge set 2 in the system are active. The information of each
bridge set includes two parts: configure and interface.

display bridge traffic

Use display bridge traffic to display bridged traffic statistics.
Syntax
display bridge traffic [ bridge-set bridge-set | dlsw | interface interface-type interface-number ] [ |
{ begin | exclude | include } regular-expression ]
Views
Any view
Default command level
2: System level
Parameters
bridge-set bridge-set: Displays the bridged traffic statistics in the specified bridge set. This argument must
be an integer in the range of 1 to 255.
dlsw: Displays the statistics of bridged traffic that has passed the DLSw module.
bridging ip, undo bridging ipx; bridging others;
undo routing ip, undo routing ipx;
bridge 1 learning
Ethernet1/1 : up
Ethernet1/2 : up
bridging ip, undo bridging ipx; bridging others;
undo routing ip, undo routing ipx;
bridge 2 learning
Ethernet1/1.1 :up
Ethernet1/1.2 :up
Description
Configuration properties of this bridge set. For example, the configuration part of
bridge set 1 indicates that bridge set 1 can bridge IP packets, not IPX packets, and
it can dynamically learn MAC addresses.
Interfaces in this bridge set and their statuses, where up represents that the interface
is active, and down represents that the interface is inactive. Bridging is possible only
between active interfaces in the same bridge set.
311