Dialer Threshold - HP MSR series Command Reference Manual

user hostname: Specifies the remote username, a string of 1 to 80 characters used for authentication on
incoming calls.
dial-number: Dial string for calling the remote end, a string of 1 to 30 characters.
autodial: Enables the device to automatically attempt to dial according to the dialer route at certain
intervals. The interval is set in the dialer timer autodial command and defaults to 300 seconds.
interface interface-type interface-number: Specifies to dial from the specified physical interface. When
multiple physical interfaces are assigned to a dialer interface and their dialup links are connected to
different ISDN switches, you must associate the dialup numbers with the physical interfaces. This
configuration is intended for dialer interfaces in C-DCC only.
Usage guidelines
To enable DCC to originate calls, you must configure the dial-number argument.
If you specify the dial-number argument in the dialer route command, when you configure a dialer route,
you must also specify the dial-number argument when using the undo dialer route command to remove
the dialer route.
If the user keyword is used, PPP authentication must be configured.
You can configure multiple dialer routes on a dialup interface or for a destination address for the backup
purpose.
If the dialer-group command is not configured, DCC does not dial.
Examples
# Dial 888066 to set up a link for packets destined to network 192.168.1.0/24.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer route ip 192.168.1.0 mask 24 888066
# Dial 888065 to set up a link for packets destined to host address 191.168.1.1.
[Sysname-Serial2/0] dialer route ip 191.168.1.1 888065

dialer threshold

Use dialer threshold to set the traffic threshold of a single link on the dialer interface.
Use undo dialer threshold to restore the default.
Syntax
dialer threshold traffic-percentage [ in | in-out | out ]
undo dialer threshold
Default
MP flow control is not enabled.
Views
Dialer interface view
Default command level
2: System level
173