X25 Local-Cug - HP MSR series Command Reference Manual

Views
Interface view
Default command level
2: System level
Usage guidelines
According to X.25, the calling request packet must carry the address. However, on some occasions, the
X.25 calling request does not have to carry the called/calling DTE address in a specific network
environment or as is required by the application. This command enables users to specify whether the call
request packet sent by X.25 in the device carries the calling DTE address.
Examples
# Specify the call request packet from the X.25 interface Serial 2/0 not to carry the calling DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 ignore calling-address
Related commands
x25 response called-address
•
x25 response calling-address
•
x25 ignore called-address
•

x25 local-cug

Use x25 local-cug to configure mapping from local CUG to network CUG and define its suppression
rule.
Use undo x25 local-cug to remove the mapping from local CUG to network CUG.
Syntax
x25 local-cug local-cug-number network-cug network-cug-number [ no-incoming | no-outgoing |
preferential ]*
undo x25 local-cug local-cug-number
Default
No CUG mapping is defined by default.
Views
Interface view
Default command level
2: System level
Parameters
local-cug-number: Number of local CUG.
network-cug-number: Number of network CUG.
no-incoming: Suppresses incoming calls.
no-outgoing: Suppresses outgoing calls.
358