Pppoe-Client - HP MSR series Command Reference Manual

Field
LocMAC
State
# Display the packet statistics on PPPoE sessions.
<Sysname> display pppoe-client session packet
PPPoE Client Session:
ID: 1
InPackets: 19
InBytes:
InDrops:
ID: 2
InPackets: 18
InBytes:
InDrops:
Table 8 Command output
Field
ID
Interface
InPackets
InBytes
InDrops
OutPackets
OutBytes
OutDrops

pppoe-client

Use pppoe-client to establish a PPPoE session and specify the dialer bundle corresponding to the session.
Use undo pppoe-client to remove a PPPoE session.
Syntax
pppoe-client dial-bundle-number number [ no-hostuniq ] [ idle-timeout seconds [ queue-length
packets ] ]
undo pppoe-client dial-bundle-number number
Default
No PPPoE session is established.
Views
Ethernet interface view, virtual Ethernet interface view, VLAN interface view
816
0
730
0
Description
Local MAC address.
PPPoE session state. PPPoE session state is the PPP protocol state.
PPPUP indicates that PPP negotiation is successful.
Interface: Eth1/1
OutPackets: 19
OutBytes: 816
OutDrops: 0
Interface: Eth1/1
OutPackets: 18
OutBytes: 730
OutDrops: 0
Description
PPPoE session ID.
Ethernet interface corresponding to a PPPoE session.
Number of packets received.
Size of received packets (in bytes).
Number of received packets discarded.
Number of packets sent.
Size of sent packets (in bytes).
Number of sent packets discarded.
60