Interface Mp-Group - HP MSR series Command Reference Manual

Usage guidelines
VA interfaces are created automatically by the system. They use the settings of the corresponding VTs. A
VA interface can be removed due to failures of lower layer connections or user intervention.
Examples
# Display the information about all the VA interfaces that are formed based on VT 1.
<Sysname> display virtual-access vt 1
Virtual-Template1:0 current state: UP
Line protocol current state: UP
Description: Virtual-Template1:0 Interface
The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened, OSICP opened
Physical is MP, baudrate: 2048000 bps
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
520 packets input, 44132 bytes, 0 drops
527 packets output, 44566 bytes, 4 drops
For the output description, see

interface mp-group

Use interface mp-group to create an MP-group interface and enter MP-group interface view. If the
interface already exists, enter its view directly.
Use undo interface mp-group to remove an MP-group interface.
Syntax
interface mp-group mp-number
undo interface mp-group mp-number
Views
System view
Default command level
2: System level
Parameters
mp-number: MP-group interface number in the range of 0 to 1023.
Usage guidelines
You must use the interface mp-group command together with the ppp mp mp-group command. You can
execute the two commands in either order.
Examples
# Create MP group 3 interface.
Table 1.
28
0/100/0
0/500/0
0/75/0