Bridge Enable - HP MSR series Command Reference Manual

Use undo bridge bridging to disable bridging of the specified network layer protocols on the specified
bridge set.
Syntax
bridge bridge-set bridging { ip | ipx | others }
undo bridge bridge-set bridging { ip | ipx | others }
Default
Bridging of all network layer protocols is enabled.
Views
System view
Default command level
2: System level
Parameters
bridge-set: Specifies the bridge set number, an integer in the range of 1 to 255.
ip: Specifies the IP protocol.
ipx: Specifies the IPX protocol.
others: Specifies other protocols than IP and IPX.
Usage guidelines
Non-routable packets will be discarded if bridging of IP or IPX is disabled in a bridge set.
Examples
# Enable IP bridging on bridge set 1.
<Sysname> system-view
[Sysname] bridge 1 bridging ip

bridge enable

Use bridge enable to enable the bridging functionality.
Use undo bridge enable to disable the bridging functionality.
Syntax
bridge enable
undo bridge enable
Default
Bridging is disabled.
Views
System view
Default command level
2: System level
303