X25 Modulo - HP MSR series Command Reference Manual

Usage guidelines
Since X.25 protocol can multiplex multiple logical virtual circuits on a physical interface, you need to
manually specify the mapping relation between all network addresses and X.121 addresses.
Once you have specified an address mapping, its contents (including protocol address, X.121 address
and all options) cannot be changed. To make modifications, you can first delete this address mapping
by using the undo x25 map command, and then establish one new address mapping.
Two or more address mappings with an identical protocol address shall not exist on the same X.25
interface.
Examples
# Set two address mappings on the X.25 interfaces Serial2/1 and Serial 2/0, respectively, and the four
address mappings have different attributes.
<Sysname> system-view
[Sysname] interface serial 2/1
[Sysname-Serial2/1] x25 map ip 202.38.160.11 x121-address 20112451 reverse-charge-request
reverse-charge-accept
[Sysname-Serial2/1] x25 map ip 202.38.160.138 x121-address 20112450 packet-size 512 512
idle-timer 10
[Sysname-Serial1/0] quit
[Sysname] interface serial2/0
[Sysname-Serial2/0] x25 map ip 20.30.4.1 x121-address 25112451 window-size 4 4 broadcast
[Sysname-Serial2/0] x25 map ip 20.30.4.8 x121-address 25112450 no-callin
Related commands
display x25 map
•
• x25 reverse-charge-accept
x25 call-facility
•
x25 timer idle
•
x25 vc-per-map
•

x25 modulo

Use x25 modulo to set the modulo mode of the X.25 interface.
Use undo x25 modulo to restore the default.
Syntax
x25 modulo { 8 | 128 }
undo x25 modulo
Default
The modulo mode of the X.25 interface is 8 mode.
Views
Interface view
Default command level
2: System level
361