Default; Description - HP MSR series Command Reference Manual

The effect of this command applies to both ATM main interface and subinterface. However, the
command is available only in ATM main interface view.
Examples
# Specify interface ATM 1/0 to use the internal transmission clock.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] clock master
Related commands
display atm interface

default

Use default to restore the default settings for the interface.
Syntax
default
Views
Layer 3 VE interface view
Default command level
2: System level
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you execute it on a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default settings of interface Virtual-Ethernet 1.
<Sysname> system-view
[Sysname] interface virtual-ethernet 1
[Sysname-Virtual-Ethernet1] default
This command will restore the default settings. Continue? [Y/N]:y

description

Use description to set VE interface description.
Use undo description to restore the default.
Syntax
description text
201