Fr Lmi Type - HP MSR series Command Reference Manual
Layer 2 wan
Hide thumbs
Also See for MSR series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
Default
The DCE-side T392 timer is 15 seconds.
Views
Interface view
Default command level
2: System level
Parameters
t392-value: Sets the DCE-side T392 timer, in seconds. The value range is 5 to 30.
Usage guidelines
The DCE-side T392 timer defines the maximum time that the DCE waits for a Status-Enquiry message.
The DCE-side T392 timer must be greater than the DTE-side T391 timer (set by the timer hold command).
Examples
# Set frame relay interface Serial 2/0 to operate in DCE mode, and set T392 to 10 seconds.
<Sysname> system-view
[Sysname] interface serial2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr interface-type dce
[Sysname-Serial2/0] fr lmi t392dce 10
fr lmi type
Use fr lmi type to configure the frame relay LMI protocol type.
Use undo fr lmi type to restore the default.
Syntax
fr lmi type { ansi | nonstandard | q933a } [ bi-direction ]
undo fr lmi type
Default
The LMI protocol type is q933a.
Views
Interface view
Default command level
2: System level
Parameters
ansi: Standard LMI protocol of ANSI T1.617 Appendix D.
nonstandard: Nonstandard compatible LMI protocol.
q933a: Standard LMI protocol of Q.933 Appendix A.
bi-direction: Responds to Status-Enquiry messages from network side in frame relay DTE mode.
The following matrix shows the command and router compatibility:
126
Advertisement
Table of Contents
