Isdn L3-Timer - HP MSR series Command Reference Manual

If you execute the isdn ignore sending-complete command with no keyword specified, the Sending
Complete Information Element-related operations are performed when a router receives a call or places
a call.
In the event that the router is communicating with an ISDN switch, its settings must be the same as those
on the switch.
Configure this command on an interface only when the ISDN protocol running on the interface is DSS1,
Q.SIG, or ETSI.
You are not allowed to configure this command on an ISDN interface if a call still exists on it. This
command can take effect only if it is configured when no call exists on the interface. Alternatively, you
can manually disable the interface by executing the shutdown command, configure the command, and
then enable the interface by executing the undo shutdown command. The operations, however, will lead
to the disconnection of the call existing on the interface.
Examples
# Ignore the Sending Complete Information Element in the received SETUP messages on interface BRI
2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn ignore sending-complete incoming
# Disable carrying the Sending Complete Information Element in the transmitted SETUP messages on
interface BRI 2/0.
[Sysname-Bri2/0] isdn ignore sending-complete outgoing

isdn l3-timer

Use isdn l3-timer to set the time-out value of an ISDN protocol L3 timer.
Use undo isdn l3-timer to restore the default time-out value of the ISDN L3 timer on the interface.
Syntax
isdn l3-timer timer-name time-interval
undo isdn l3-timer { timer-name | all }
Default
An ISDN protocol L3 timer varies by ISDN protocol type. See
Views
ISDN interface view
Default command level
2: System level
Parameters
timer-name: Name of a L3 timer of the ISDN protocol (see
time-interval: Time-out value, which can be one of the values listed in
all: Restores the default time-out values of all the L3 timers.
Table
Table 14).
84
14.
Table 14.