Mode Led View Button And Indicator Leds - HP J4897A Installation Manual

Introducing the HP Procurve Series 2700 Switches
Front of the Switch

Mode LED View Button and Indicator LEDs

To optimize the amount of information that can be displayed for each of the
switch ports, the Series 2700 Switches use a Mode LED for each port. The
operation of this LED is controlled by the Mode LED View button, and the
current setting is indicated by the Mode indicator LEDs near the button. Press
the button to change from one mode to the next.
Mode LED View button
and indicator LEDs
■
■
■
1-4
Mbps
Mbps
Mbps
If the Activity (Act) indicator LED is lit, the Mode LED for each port
displays activity information for the port — it flickers as network traffic
is received and transmitted through the port.
If the Full Duplex (FDx) indicator LED is lit, the Mode LEDs light for those
ports that are operating in full duplex.
If the Speed (Spd) indicator LED is lit, the Mode LEDs behave as follows
to indicate the connection speed for the port:
• Off = 10 Mbps
• Flashing = 100 Mbps (the flashing behavior is a repeated 1.6 sec. cycle
of two quick flashes followed by an off period)
• On = 1000 Mbps
Mode LEDs
(one per port)