Table 309: Description Of Configuration Scripts For "Snmp - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G

Table 309: Description of Configuration Scripts for "SNMP"

Parameters Status Call-Up
SNMP Trap Receiver Configuration for v1 and v2c
Any number of trap receivers can be configured. A trap receiver that has been set up is always
active; the data set must be completely deleted to deactivate it.
IP address of a
trap receiver
Community
Name
Trap version
Creating/
deleting a trap
receiver
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
get_snmp_data
read v1-v2c-trap-receiver-
address <Nummer>
get_snmp_data
v1-v2c-trap-receiver-
read
community-name
<Nummer>
get_snmp_data
read v1-v2c-trap-receiver-
version <Nummer>
config_snmp
v1-v2c-trap-receiver-
edit=<Value1>
v1-v2c-trap-receiver-
address=<Value2>
write
v1-v2c-trap-receiver-
community-
name=<Value3>
v1-v2c-trap-receiver-
version=<Value4>
Appendix 393
Output/Input
Specifies the IP address of the
trap receiver that the controller is
to send the v1 or v2 traps to.
The <number> parameter
enables consecutive reading of
related data from the individually
configured trap receiver for a
short period of time (without
interim changing of the data).
This is a consecutive number that
is not connected to the data. If
the number is not included, the
data of the first receiver are read.
Specifies the community name
that the SNMP agent of the
controller sends in the Trap
Header.
Parameter <number> see section
"IP Address of a Trap Receiver".
Specifies the SNMP version ("v1"
or "v2c") via which the SNMP
agent sends the traps to the
associated trap receiver address.
Parameter <number> see section
"IP Address of a Trap Receiver".
Create a new trap receiver
(value1=add) or delete an
already configured trap receiver
(value1=delete).
Other parameters:
<Value2> = IP address
(number.number.number.number
) that the controller is to send the
traps to.
<Value3>: Community string
(string), which the controller
enters in the trap header.
<Value4>: SNMP version, via
which the traps are sent (v1 or
v2c).
Note:
All parameters must also be
entered when deleting a trap
receiver, as this is the only
means to uniquely identify the
data set.
Valid
Right
away
Right
away
Right
away
After
restart
Manual