WAGO 750-8207 Manual page 282

282 MODBUS – CODESYS 2
Table 205: MODBUS RTU Settings
Parameters
Flow control
Physical
interface
*
Default setting
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Data flow control (Supported only for the setting "RS-232" for the
physical interface.)
*
None No data flow control
RTS/CTS Hardware flow control
Mode for the physical interface
*
RS-232 RS-232 is used as the physical interface.
RS-485 RS-485 is used as the physical interface.
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G