Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.1.37
"Configuration of OpenVPN and IPsec" Page
The general settings for SNMP v1/v2c are shown on the "Configuration of SNMP
v1/v2c Parameters" page.
7.8.1.37.1 "OpenVPN" Group
Table 107: WBM "Configuration of OpenVPN and IPsec" Page – "OpenVPN" Group
Parameters
Current State
OpenVPN enabled
openvpn.config
To apply a status change, click the [Submit] button.
To select a file on the controller or PC, click the [Browse] button.
To transfer the selected file from the PC to the controller, click [Start Upload]
button.
To transfer the selected file from the controller to the PC, click [Start Download]
button.
The changes only take effect after restarting the controller. For this purpose, use
the WBM reboot function. Do not shut down the controller too early!
7.8.1.37.2 "IPsec" Group
Table 108: WBM "Configuration of OpenVPN and IPsec" Page – "IPsec" Group
Parameters
Current State
IPsec enabled
ipsec.config
ipsec.secrets
To apply a status change, click the [Submit] button.
To select a file on the controller or PC, click the [Browse] button.
To transfer the selected file to the controller, click [Start Upload] button.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
The current status of the OpenVPN service is
displayed.
stopped
The service is disabled.
running
The service is enabled.
Enable or disable the OpenVPN service.
Select an OpenVPN configuration file to be
transferred from PC to controller or vice versa.
Explanation
The current status of the IPsec service is displayed.
stopped
The service is disabled.
running
The service is enabled.
Enable or disable the IPsec service.
Select an IPsec configuration file to be transferred
from PC to controller or vice versa.
Select an IPsec configuration file to be transferred
from PC to controller.
Commissioning 159
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
