General Configuration" > "Interface Xxx" Submenu; Table 146: "Firewall" > "General Configuration" > "Interface Xxx" Submenu - WAGO 750-8207 Manual

184 Commissioning
7.8.4.5.2 "General Configuration" > "Interface xxx" Submenu
This submenu contains the firewall settings on the IP level for the selected
interface.
Table 146: "Firewall" > "General Configuration" > "Interface xxx" Submenu
Menu Item
0. Back to ...
1. Interface state
2. ICMP Policy
3. ICMP Limit
4. ICMP Burst
5. Telnet
6. FTP
7. FTPS
8. HTTP
9. HTTPS
10. I/O-CHECK
11. PLC Runtime
12. PLC WebVisu –
direct link (port 8080)
13. SSH
14. TFTP
15. BootP/DHCP
16. DNS
17. MODBUS TCP
18. MODBUS UDP
19. SNMP
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Submenu Item / Explanation
Back to the higher-level menu
Enable or disable the firewall for the selected
interface.
0. Back to ... Back to the higher-level menu
The firewall for the selected interface
1. Open
is disabled.
The firewall for the selected interface
2. Filtered
is enabled.
Enable or disable the "ICMP echo" protection for the
respective interface.
0. Back to ... Back to the higher-level menu
The "ICMP echo" protection is
1. Accept
disabled.
The "ICMP echo" protection is
2. Drop
enabled.
You can specify the maximum number of "ICMP
pings" per second.
"0" = "Disabled"
You can specify the maximum number of "ICMP
echo bursts" per second.
"0" = "Disabled"
Enable or disable the firewall for the respective
service.
The services themselves must be enabled or
disabled separately on the "Ports and Services"
page.
WAGO-I/O-SYSTEM 750