Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.4.4.5 "TCP/IP" > "IP Address" Submenu
This submenu contains other submenus with settings for the ETHERNET
interfaces.
The submenu only appears if the controller is operated in "Separated" mode.
If the controller is operated in "Switched" mode, then the "IP Address" > "X1"
submenu is displayed directly.
Table 135: "Networking" > "IP Address" Submenu
Menu Item
0. Back to ...
1. X1
2. X2
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.8.4.4.6 "IP Address" > "Xn" Submenu
This submenu contains the settings for the selected interface.
Table 136: "Networking" > "TCP/IP" > "IP Address" Submenu > "Xn"
Menu Item
0. Back to ...
1. Type of IP Address
Configuration
2. IP Address
3. Subnet Mask
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Back to the higher-level menu
Opens a submenu with settings for the X1 interface
Opens a submenu with settings for the X2 interface
Submenu Item / Explanation
Back to the higher-level menu
Select a static or dynamic IP address.
0. Back to ... Back to the higher-level menu
Static IP addressing
When selecting static addressing, the
1. Static IP
IP address and subnet mask are then
retrieved.
2. DHCP
Dynamic IP addressing
3. BootP
Dynamic IP addressing
Enter here a static IP address.
Enter the subnet mask.
Commissioning 177
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
