Inserting A Memory Card During Operation; Removing The Memory Card During Operation - WAGO 750-8207 Manual

70 Function Description
4.2.3

Inserting a Memory Card during Operation

The fieldbus nodes and the PLC program are running.
Insert a memory card during ongoing operation.
During normal operation, the memory card is incorporated into the file system of
the controller as a drive.
No automatic copy procedures are triggered.
The LED above the memory card flashes yellow/orange during the access.
The memory card is then ready for operation and available under /media/sd.
4.2.4

Removing the Memory Card during Operation

The fieldbus node and the PLC program are in operation and the memory card is
plugged in.
Remove the memory card during ongoing operation.
Data can be lost during writing!
Note that if you pull the memory card out during a write procedure, data will be
lost.
The LED above the memory card flashes yellow/orange during the attempted
access.
The controller then works without a memory card.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G