Power Supply Concept; Fuse Protection Of The Electronic Circuit Power Supply; Figure 28: Fuse Protection Of The Electronic Circuit Power Supply - WAGO 750-8207 Manual

80 Connect Devices
6.2

Power Supply Concept

6.2.1

Fuse Protection of the Electronic Circuit Power Supply

Only implement the electronic circuit power supply with a suitable fuse!
The electronic power supply of the controller must only be connected via a slow
blow 2A fuse, as shown in the following figure. The electronics may be damaged
with higher currents.

Figure 28: Fuse Protection of the Electronic Circuit Power Supply

Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G