Setting An Ip Address; Table 37: Default Ip Addresses For Ethernet Interfaces; Table 38: Network Mask 255.255.255.0 - WAGO 750-8207 Manual

84 Commissioning
7.3

Setting an IP Address

In the controller's initial state the following IP addresses are active for the
ETHERNET interface (Port X1 and Port X2):

Table 37: Default IP Addresses for ETHERNET Interfaces

Ethernet interface
X1/X2
Adapt IP addressing for your specific system structure to ensure that the PC and
the controller can communicate with one another using one of the available
configuration tools (WBM, "WAGO Ethernet Settings", CBM) (see section
"Configuration").
Example for incorporating the controller (192.168.2.17) into an existing
network:
If the IP address of your host PC is 192.168.1.2, for example, then the controller
must be on the same subnet. That is, with the net mask 255.255.255.0, the first
three digits of the controller must match those of your PC. This yields the
following address range for the controller:

Table 38: Network Mask 255.255.255.0

Host PC
192.168.1.2
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Default setting
Dynamic assignment of IP address using "Dynamic Host
Configuration Protocol" (DHCP)
Subnet address range for the controller
192.168.1.3 ... 192.168.1.254
WAGO-I/O-SYSTEM 750