Ports And Services" > "Modbus Udp" Submenu; Ports And Services" > "Plc Runtime Services" Submenu; Table 179: "Ports And Services" > "Modbus Udp" Submenu; Table 180: "Ports And Services" > "Plc Runtime Services" Submenu - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.4.11.14 "Ports and Services" > "Modbus UDP" Submenu
This submenu contains the settings for the MODBUS UDP service.
Table 179: "Ports and Services" > "Modbus UDP" Submenu
Menu Item
0. Back to ...
1. State
2. Firewall status
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
7.8.4.11.15 "Ports and Services" > "PLC Runtime Services" Submenu
This submenu contains the settings for the PLC runtime system services.
Table 180: "Ports and Services" > "PLC Runtime Services" Submenu
Menu Item
0. Back to ...
1. General Configuration
2. CODESYS 2
3. e!RUNTIME
4. Change CODESYS
Runtime firewalling
settings
5. Change CODESYS
WebVisu firewalling
settings
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Submenu Item / Explanation
Back to the higher-level menu
Disable/enable the MODBUS UDP service.
0. Back to ... Back to the higher-level menu
The MODBUS UDP service is
1. Enable
enabled.
The MODBUS UDP service is
2. Disable
disabled.
Opens a submenu with firewall settings for the this
service for the interfaces
Explanation
Back to the higher-level menu
Enter the password for port authentication.
Opens a submenu with service settings for
CODESYS 2
Opens a submenu with service settings for
e!RUNTIME
Opens a submenu with firewall settings for the this
service for the interfaces
Opens a submenu with firewall settings for the this
service for the interfaces
Commissioning 207
Manual