Creating The Plc Configuration; Figure 53: Creating A New Function Block; Figure 54: Programming Interface With The Plc_Prg Program Module - WAGO 750-8207 Manual

224 Run-time System CODESYS 2.3
5. In this "New component" window create a new program function block. In
the example shown here, the new function block "PLC_PRG" is created in
the "ST" programming language.
6. Click on [OK] to create the project. The programming interface opens.

Figure 53: Creating a New Function Block

Figure 54: Programming Interface with the PLC_PRG Program Module

8.2.3

Creating the PLC Configuration

Procedure for Creating the PLC Configuration
The procedure explained in this section describes the PLC configuration for the
I/O modules connected to the controller.
Information about the controller function for any fieldbuses connected to the
system is given in the section on the specific fieldbus.
The PLC configuration is used to configure the fieldbus controller, along with the
connected I/O modules and to declare variables for accessing the inputs and
outputs of the I/O modules.
1. Click on the "Resources" tab.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G