Table 304: Description Of The Configuration Scripts For "Administration; Table 305: Description Of Configuration Scripts For "Package Server - WAGO 750-8207 Manual

386 Appendix

Table 304: Description of the Configuration Scripts for "Administration"

Parameters Status Call
Configuration of Service Interface
Configuration of
Service
Interface
Reboot Controller
-
</dg_

Table 305: Description of Configuration Scripts for "Package Server"

Parameters Status Call-Up
Firmware Update
Medium for
active partition
Create
firmware
backup
</dg_
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
get_service_interface_
read
config mode
config_service_interface
write
_config mode=<value>
write start_reboot
get_filesystem_data
read
active-partition-medium
firmware_backup
package-
settings=<Value1>
package-
codesys=<Value2>
write
package-
system=<Value3>
device-
medium=<Value4>
auto-update=<Value5>
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Output/Input
User of the serial interface.
Possible return values are:
- service (WAGO-I/O-CHECK,
WAGO-I/O-PRO,
e!COCKPIT)
®
- linux (Linux console)
- free (unused, free for
application)
User of the serial interface.
Possible entries for <value>:
- service
- linux
- free
Restart the controller.
Output/Input
Specifies the medium for the
active partition
(memory card, internal flash).
Generates a backup of the
selected packet on the specified
medium.
Parameter:
<Value1> = 1, if "Settings" packet
is to be selected.
<Value2> = 1, if the "CODESYS
Project" packet is to be selected.
<Value3> = 1, if the "System"
packet is to be selected.
<Value4> = Target medium for
saving the backup.
(memory card, internal flash)
<Value5> = 1, if Auto Update is
to be activated.
Parameters, which are not to be
set (1) can either be set to 0 or
omitted completely.
Effecti
ve
immedia
tely
immedia
tely
Valid
Right
away
Right
away