Configuration Using A Terminal Program (Cbm); Cbm Menu Structure Overview; Figure 44: Cbm Main Menu (Example); Table 113: Cbm Menu Structure - WAGO 750-8207 Manual

164 Commissioning
7.8.4

Configuration using a Terminal Program (CBM)

You can use the Console-Based Management Tool (CBM) to configure the
controller via the ETHERNET interface and SSH, as well as the RS-232 interface
and Linux
To establish a connection via the serial interface, set the baud rate to 115200
baud in the terminal program. The settings for data bits, stop bits and parity do
not need to be adjusted.
To launch the CBM, log in to the Linux
(case sensitive).

Figure 44: CBM main menu (example)

7.8.4.1

CBM Menu Structure Overview

Table 113: CBM Menu Structure

Menu Hierarchy
0. Quit
1. Information
0. Back to Main Menu
1. Controller Details
2. Network Details
2. PLC Runtime
0. Back to Main Menu
1. Information
2. General Configuration
3. WebVisu
3. Networking
0. Back to Main Menu
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
®
console.
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
®
console and enter the command "cbm"