Configuration - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8

Configuration

The following methods are available for configuring the controller:
• Access to the Web-based management system via the PC using an
Internet browser ("Configuration using Web-Based Management [WBM]")
• Access to the "Console-Based Management" system (CBM) via the PC
using a terminal program (via ETHERNET and/or RS-232 interface;
"Configuration Using a Terminal Program")
• Access via the CODESYS PLC program using the WagoConfigToolLIB.lib
library ("Appendix" > "WagoConfigToolLIB.lib")
• Access via the PC using "WAGO Ethernet Settings" ("Configuration Using
'WAGO Ethernet Settings'").
The CBM is basically for the initial configuration and startup of the controller.
Therefore, it only provides a subset of the WBM parameters. For example,
parameters that cannot be displayed in a terminal window in a reasonable way
and are not necessary for initial startup are not displayed. You can find the
explanations of the parameters starting with the section "'Information' Page."
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Commissioning 97
Manual