Changing An Ip Address Using "Wago Ethernet Settings; Figure 37: "Wago Ethernet Settings" - Starting Screen (Example) - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.3.3

Changing an IP Address using "WAGO Ethernet Settings"

The Microsoft Windows
used to identify the controller and configure network settings.
Observe the software version!
To configure the controller use at least Version 6.4.1.1 dated 2015-06-29 of
"WAGO Ethernet Settings"!
You can use WAGO communication cables or WAGO radio adapters or even the
IP network for data communication.
1. Switch off the power supply to the controller.
2. Connect the 750-920 communication cable to the Service interface on the
controller and to a serial interface of your PC.
3. Switch the power supply to the controller on again.
4. Start the "WAGO Ethernet Settings" program.
Figure 37: "WAGO Ethernet Settings" – Starting Screen (Example)
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
®
application "WAGO Ethernet Settings" is a software
Commissioning 89
Manual