Table of Contents
Advertisement
110 Commissioning
7.8.1.6
"PLC WebVisu" Page
The settings for the web visualization created in the runtime system are shown
on the "PLC WebVisu" page.
7.8.1.6.1 "Web Server Configuration" Group
Table 47: WBM "PLC WebVisu" Page – "Web Server Configuration" Group
Parameters
CODESYS 2 Webserver
State
e!RUNTIME Webserver
State
Default Webserver
Click [Submit] to apply change. The change is effective immediately.
In its default setting, the WBM is called up when only entering the IP address.
To update the display after switching, enter the IP address again in the address
line of the web browser.
To display the web visualization, the web server must be enabled (in WBM under
"Ports and Services" -> "PLC Runtime Services") and there must be a suitably
configured application.
Regardless of the default web server setting, the WBM can be called up at any
time with "https://<IP address>/wbm" and the web visualization with
"https://<IP address>/webvisu."
You can obtain additional information on CODESYS 2 web visualization in the
section of the same name.
Possible error messages when calling up the web visualization
The "500 − Internal Server Error" message indicates that the web server is not
enabled.
A page with the header "WebVisu not available" means that no application has
been loaded in the controller using web visualization.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
This indicates the status (enabled/disabled) of the
CODESYS 2 web server.
This indicates the status (enabled/disabled) of the
e!RUNTIME web server.
Choose here whether the Web-based Management
or web visualization of the runtime system should be
displayed when only entering the IP address of the
controller.
Web-based
The Web-based Management is
Management
displayed.
Web-Visu
The web visualization of the runtime
system is displayed.
WAGO-I/O-SYSTEM 750
Advertisement
Chapters
Table of Contents
Troubleshooting
