Information" > "Runtime Version" Submenu; Information" > "Webserver Version" Submenu; Information" > "State" Submenu; Table 119: "Plc Runtime" > "Information" > "Runtime Version" Submenu - WAGO 750-8207 Manual

170 Commissioning
7.8.4.3.2 "Information" > "Runtime Version" Submenu
In this submenu, the runtime version is displayed.
Table 119: "PLC Runtime" > "Information" > "Runtime Version" Submenu
Parameters
Version
To return to the higher-level menu, press [Q] or [Return].
7.8.4.3.3 "Information" > "Webserver Version" Submenu
In this submenu, the Webserver version is displayed.
The submenu only appears when CODESYS 2 is enabled as the runtime system.
Table 120: "PLC Runtime" > "Information" > "Webserver Version" Submenu
Parameters
Version
To return to the higher-level menu, press [Q] or [Return].
7.8.4.3.4 "Information" > "State" Submenu
In this submenu, the PLC operating state is displayed.
The submenu only appears when CODESYS 2 is enabled as the runtime system.
Table 121: "PLC Runtime" > "Information" > "State" Submenu
Parameters
State
To return to the higher-level menu, press [Q] or [Return].
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
The version of the currently enabled runtime system
is shown. If the runtime system is disabled, "None"
is displayed.
Explanation
The Webserver version is displayed.
Explanation
The PLC operating state is shown.
STOP PLC program is not executed.
RUN PLC program is executed.
WAGO-I/O-SYSTEM 750