Table of Contents
Advertisement
108 Commissioning
7.8.1.5
"PLC Runtime Information" Page
All information about the enabled runtime system and PLC program created in
the programming software is provided on the "PLC Runtime Information" page.
7.8.1.5.1 "PLC Runtime" Group
Table 44: WBM "PLC Runtime Information" Page – "PLC Runtime" Group
Parameters
Version
Web Server Version
State
Number of Tasks
7.8.1.5.2 "Project Details" Group
This group is only visible if CODESYS 2 is enabled as the runtime system.
Table 45: WBM "PLC Runtime Information" Page – "Project Details" Group
Parameters
Date
Title
Version
Author
Description
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
The version of the currently activated runtime
system is shown here.
If the runtime system is disabled, "None" is
displayed and the subsequent fields of this group
are disabled.
This shows the version number of the web server.
This field is only visible when CODESYS 2 is
enabled as the runtime system.
The PLC operating state is shown. This field is only
visible when CODESYS 2 is enabled as the runtime
system.
STOP
PLC program is not executed.
RUN
PLC program is executed.
The number of tasks in the PLC program is shown.
This field is only visible when CODESYS 2 is
enabled as the runtime system.
Explanation
Display of project information that the programmer
entered in the PLC program (in programming
software under Project > Project Information...).
The information only appears when a PLC program
is run.
Descriptive texts up to 1024 characters long are
given under "Description."
WAGO-I/O-SYSTEM 750
Advertisement
Chapters
Table of Contents
Troubleshooting
