Loading And Running The Plc Program In The Fieldbus Controller (Ethernet); Figure 68: Creating A Communication Link - Step 1 - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
8.2.5 Loading and Running the PLC Program in the Fieldbus
Controller (ETHERNET)
Requirement:
- The simulation is deactivated (Online > Simulation).
- The PC is linked to the controller via ETHERNET. Refer to Section "Device
Description" > ...> "ETHERNET – X1, X2 Network Connection".
Proceed as follows:
1. In the menu bar click on Online and select Communication parameters
.... The "Communication Parameters" window opens.
2. To select a communication link, click on [New ...] in the "Communication
Parameters" window. A window opens in which you can define a
communication link.
Figure 68: Creating a Communication Link – Step 1
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Run-time System CODESYS 2.3 233
Manual