Table 230: Diagnostics Via Net Led - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G

Table 230: Diagnostics via NET LED

Status
Green
Orange
Red
Red flashing,
blink code 1-1
Red flashing,
blink code 1-2
Red flashing,
blink code 2-1
Red flashing,
blink code 2-2
Red flashing,
blink code 2-3
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
3G network
2G network
No network
No SIM card inserted -
Invalid/locked SIM
card
Modem not
connected
Modem initialization
error (incompatible
firmware version)
Timeout for modem
reset
Remedy
---
---
- Check the SIM status via WBM.
- Enter the PIN or PUK if necessary.
- If the SIM status is "ready" and the
error persists, check the antenna
and its connection to the device.
- If necessary, connect the antenna
correctly or use another compatible
antenna.
- If possible, use a mobile phone or
comparable device to check the
signal quality of the mobile network
locally.
Switch off the device.
- Insert a SIM card.
- Switch the device on again.
- Switch off the device.
- Insert a different SIM card that is
valid.
- Switch the device on again.
A hardware fault is present. Contact
WAGO Support.
Load the modem firmware originally
included as delivered from the factory
back onto the device.
Switch the device off and on again.
Diagnostics 325
Manual