Wagolibcpuusage.lib; Wagolibdiagnosticids.lib - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Table 309: Description of Configuration Scripts for "SNMP"
Parameters Status Call-Up
Add new v3-
User
Delete v3 user

15.2.1.10 WagoLibCpuUsage.lib

The controller 750-8207supports the following function blocks of the
"WagoLibCpuUsage.lib" library:
- CPU_Usage
The document containing the description of the library and the function block it
includes is available for download on the Internet at www.wago.com.

15.2.1.11 WagoLibDiagnosticIDs.lib

The controller 750-8207supports the following function blocks of the
"WagoLibDiagnosticIDs.lib" library:
- DIAGNOSTIC_SEND_ID
- DIAGNOSTIC_SET_TEXT_FOR_ID
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
config_snmp
v3-edit=add
v3-auth-name=<Value1>
v3-auth-type=<Value2>
v3-auth-key=<Value3>
write
v3-privacy=<Value4>
v3-privacy-
key=<Value5>
v3-notification-
receiver=<Value6>
config_snmp
write v3-edit=delete
v3-auth-name=<Value>
Appendix 395
Output/Input
Creating a new v3 user.
v3-auth-name: User name, string
without spaces, maximum of 32
characters. This must be a new,
unique user name.
Parameters:
User name (<Value1> = string)
Encryption method. (<Value2> =
none, MD5 or SHA).
Key string for authentication,
(<Value3> = String with at least
eight and a maximum of 32
characters)
Privacy encryption method
(<Value4> = none, DES or AES).
Privacy key string (<Value5> =
String with at least eight and a
maximum of 32 characters), can
also be blank; in this case the
authentication key will be used.
The IP address of a trap receiver
is transmitted as the notification
receiver (<Value6> =
number.number.number.number)
. This parameter is not required if
no v3 traps are to be sent.
Deleting a v3 user that has been
set up.
Because the doubled allocation
of the same user name is
prevented when creating a user,
the name is sufficient to uniquely
identify a data set (<Value> =
string).
Valid
After
restart
After
restart
Manual