Mobile Network Configuration" Group; Table 103: Wbm "Configuration Of Internal 3G Modem" Page - "Mobile Network - WAGO 750-8207 Manual

Pfc200 cs 2eth rs 3g plc - controller pfc200
Table of Contents

Advertisement

156 Commissioning

7.8.1.36.2 "Mobile Network Configuration" Group

Table 103: WBM "Configuration of internal 3G Modem" Page – "Mobile Network Configuration" Group
Parameters
State
Signal Quality (%)
Operator
Selection Mode
Provider
* However, the restriction applies only when more than one possible network is
available, e.g., if "Automatic UMTS only" is selected, but only a GSM network is
available from the provider, then the modem still logs into the GSM network.
Click on [Submit] to accept the changes. The changes will be effective
immediately.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
The network status is displayed.
The current signal quality is displayed.
The provider and network type currently in use are
displayed.
Select the mode for selecting the provider used:
The network is selected by the
Automatic
modem itself based on the SIM
card settings.
Automatic –
Like "Automatic", but the UMTS
UMTS preferred
network is preferred.
Automatic –
Like "Automatic", but the GSM
GSM preferred
network is preferred.
Automatic –
Like "Automatic", but restricted to
UMTS only
the UMTS network.*
Automatic –
Like "Automatic", but restricted to
GSM only
the GSM network.*
Manual network selection from
the Provider selection list;
if you set the "Manual" mode, the
Manual
provider list is then refreshed.
This may take some time (see
section "'Provider List' Group").
Select the provider.
The field is only visible if Selection Mode is set to
"Manual".
The selection list contains all providers from the
provider list that are actually available.
The selection list is only available if the provider list
has been refreshed.
WAGO-I/O-SYSTEM 750

Advertisement

Table of Contents
loading

Table of Contents