Connect Devices; Connecting A Conductor To The Cage Clamp; Figure 27: Connecting A Conductor To A Cage Clamp - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
6

Connect Devices

6.1

Connecting a Conductor to the CAGE CLAMP

The WAGO CAGE CLAMP
finely stranded conductors.
Select conductor cross sections as required for current load!
The current consumed for field-side supply may not exceed 10 A. The wire cross
sections must be sufficient for the maximum current load for all of the I/O
modules to be supplied with power.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
1. To open the CAGE CLAMP
above the connection.
2. Insert the conductor into the corresponding connection opening.
3. To close the CAGE CLAMP
clamped firmly in place.

Figure 27: Connecting a Conductor to a CAGE CLAMP

Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
®
connection is appropriate for solid, stranded and
®
insert the actuating tool into the opening
®
simply remove the tool - the conductor is then
®
Connect Devices
®
®
connection!
®
connection.
Manual
79