Figure 63: Variable Declaration; Figure 64: Control Configuration: I/O Modules With Their Associated Addresses - WAGO 750-8207 Manual

230 Run-time System CODESYS 2.3
To close the I/O Configurator, click [OK].
13.
14. The individual inputs and outputs of the selected I/O module are displayed
in the right half of the configuration window.
Here, you can declare a dedicated variable in the "Name" column for each
input and output, e.g., "Output_1", "Output_2", "Input_1", "Input_2".

Figure 63: Variable declaration

15. The added I/O modules appear in the control configuration under
"K-Bus[FIX]" with their associated fixed addresses and, where applicable,
their previously set variable name.

Figure 64: Control Configuration: I/O Modules with Their Associated Addresses

Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G