Removing The I/O Module; Figure 122: Removing The I/O Module (Example) - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
14.1.2

Removing the I/O Module

1. Remove the I/O module from the assembly by pulling the release tab.

Figure 122: Removing the I/O Module (Example)

Electrical connections for data or power jumper contacts are disconnected when
removing the I/O module.
Do not take the controller enclosure apart!
The enclosure sections are firmly joined. The feed-in section with the CAGE
®
CLAMP connections cannot be separated from the other enclosure section.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Removal 343
Manual