Editing The Program Function Block; Figure 65: Program Function Block; Figure 66: Input Assistant For Selecting Variables - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
8.2.4

Editing the Program Function Block

To edit the PLC_PRG program function block, go to the "Function block" tab and
double-click on the PLC_PRG program module.

Figure 65: Program Function Block

The following example illustrates the editing of the program function block. To do
this, an input is assigned to an output:
1. Press [F2] to open the Input assistant, or right click and select "Input
assistant" from the contextual menu.

Figure 66: Input Assistant for Selecting Variables

2. Under "Global variables" select the previously declared variable "Output_1"
and click [OK] to add it.
3. Enter the allocation "=" behind the variable name.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Run-time System CODESYS 2.3 231
Manual