Firmware Restore" Page; Table 72: "Firmware Restore" Wbm Page - WAGO 750-8207 Manual

134 Commissioning
7.8.1.20

"Firmware Restore" Page

The settings for restoring the controller data are shown on the "Firmware
Restore" page.

Table 72: "Firmware Restore" WBM Page

Parameters
Source
Packages
CODESYS backup file
Settings backup file
System backup file
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
Select the data source for the restore here.
The data is read from the memory
card.
Memory card This selection is only enabled if a
memory card without system data is
inserted.
The data is uploaded from the PC
Network
and restored.
Select the data to be restored here.
To do this, select the corresponding entries.
All data is restored.
This selection only appears if the
All
memory card is selected as the data
source.
PLC runtime
The PLC runtime project is restored.
project
Settings The controller settings are restored.
The controller operating system is
System loaded. The current controller
settings are retained.
Enter the name of the backup file for the CODESYS
project here.
The input field only appears if the network is
selected as the data source.
Enter the name of the backup file for the settings
here.
The input field only appears if the network is
selected as the data source.
Enter the name of the backup file for the system
data here.
The input field only appears if the network is
selected as the data source.
WAGO-I/O-SYSTEM 750