WAGO 750-8207 Manual page 389

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Table 307: Description of Configuration Scripts for "Ports and Services" – "PLC Runtime Services"
Parameters Status Call
CODESYS 2 Settings
CODESYS2
Webserver
State
CODESYS2
Port
Authentication
CODESYS2
Service State
CODESYS2
Communication
Port
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
get_runtime_config cfg-
read version=2 Webserver-
state
config_runtime cfg-
write version=2 Webserver-
state=<value>
get_runtime_config cfg-
read
version=2 authentication
config_runtime cfg-
write version=2
authentication=<value>
get_runtime_config
read
service-state
config_runtime service-
write
state=<value>
get_runtime_config
read
comm-port
config_runtime comm-
write
port=<value>
Appendix 389
Output/Input
Read status of the runtime-
specific Webserver
Possible return values:
- enabled
- disabled
Enable/disable runtime-specific
Webserver
Possible entries for <value>:
- enabled
- disabled
Read status of the port
authentication for communication
between the CODESYS 2 PC
software and the controller
Possible return values:
- enabled
- disabled
Possible entries for <value>:
- enabled
- disabled
Read status of the port for
communication between the
CODESYS 2 PC software and
the controller
Possible return values:
- enabled
- disabled
Possible entries for <value>:
- enabled
- disabled
Read value of set network port
for communication between PC
and controller
Default value is 2455
Change port number
Enter the TCP/IP port number for
<value>.
Effecti
ve
Immedia
tely
Immedia
tely
Immedia
tely
Immedia
tely
Manual