Table of Contents
Advertisement
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.1.9
"Ethernet Configuration" Page
The settings for Ethernet TCP/IP are located on the "Ethernet Configuration"
page.
7.8.1.9.1 "Switch Configuration" Group
Table 53: WBM "Ethernet Configuration" Page – "Switch Configuration" Group
Parameter
Interfaces
Port Mirror
Fast Aging enabled
Broadcast Protection
Rate Limit
Click [Submit] to apply the change. The change is effective immediately.
7.8.1.9.2 "Interface Xn" Groups
One group ("Interface X1" / "Interface X2") is displayed for each connection.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Enable or disable the switch.
Both interfaces are operated with one
Switched
IP address.
Each interface is operated with its own
Separated
IP address.
Enable or disable the mirroring of the data traffic
between the ports.
None
Both Ethernet ports operating normally.
The entire data traffic between X1 and
X1
the PFC system is mirrored at port X2.
The entire data traffic between X2 and
X2
the PFC system is mirrored at port X1.
Set here the aging time of unused entries in the list
of MAC addresses with a port assignment to
external network stations.
An unused address entry becomes
Disabled
obsolete after 200 seconds.
An unused address entry becomes
Enabled
obsolete after 800 microseconds.
Set here the broadcast limit for protection against
overloads.
Disabled
No limitation of broadcast packets.
Limitation of incoming broadcast
packets to the selected percentage of
1 % ... 5 %
the total possible data throughput
(10/100Mbit).
Set here the basic limitation of the incoming data
traffic.
Disabled
No limitation of the incoming data traffic
64 kbps ...
Limitation of the incoming data traffic to
99 mbps
the entered value
Commissioning 115
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
