Configuration Using "Wago Ethernet Settings; Figure 45: "Wago Ethernet Settings" - Start Screen - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
</dg_
7.8.5

Configuration using "WAGO ETHERNET Settings"

The "WAGO ETHERNET Settings" program enables you to read system
information about your controller, make network settings and enable/disable the
Web server.
Observe the software version!
To configure the controller, use at least Version 6.4.1.1 dated 2015-06-29 or
newer of "WAGO ETHERNET Settings"!
You must select the correct COM port after starting "WAGO ETHERNET
Settings".
Figure 45: "WAGO ETHERNET Settings" – Start Screen
For this, click "Settings" and then "Communication".
In the "Communication settings" window that then opens, adapt the settings to
your needs.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Commissioning 215
Manual