Firmware Backup" Page; Table 71: "Firmware-Backup" Wbm Page - WAGO 750-8207 Manual

132 Commissioning
7.8.1.19

"Firmware Backup" Page

You can find the controller data backup settings on the "Firmware Backup" page.

Table 71: "Firmware-Backup" WBM Page

Parameters
Packages
Destination
Activate "auto update
feature"
Note the firmware version!
Restoring the controller operating system ("System" selection) is only permissible
and possible if the firmware versions at the backup and restore times are
identical.
If necessary, skip restoring the controller operating system, or match the
firmware version of the controller to the firmware version of the backup time
beforehand.
Only one package may be copied to the network!
If you have specified "Network" as the storage location, only one package may
be selected for each storing process.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
You can select the data to be backed up here.
To do this, select the corresponding entries.
All data is backed up.
This selection is only enabled if the
All
memory card is selected as the
target.
PLC runtime The PLC runtime project is backed
project up.
The controller settings are backed
Settings
up.
The controller operating system is
System
backed up.
Select the storage location for the backup here.
The data is written to the memory
card.
Memory card This selection only appears if a
memory card without system data is
inserted.
The data are stored on the file
Network system and can then be
downloaded to the PC.
To start the automatic update when a memory card
with system data is inserted, select this button.
WAGO-I/O-SYSTEM 750