WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.4.5.7 "User Filter" > "Add New / No (n)" Submenu
In this submenu, you can create, change or delete filter entries.
Table 151: "Firewall" > "User Filter" > "Add New / No (n)" Submenu
Menu Item
0. Back to ...
1. Source IP address
2. Source netmask
3. Source port
4. Destination IP address
5. Destination netmask
6. Destination port
7. protocol
8. interface
9. state
10. accept
11. delete
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
Click [<OK>] to apply the entry.
Click [<Abort>] to discard the entry.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Submenu Item / Explanation
Back to the higher-level menu
Enter the source IP address.
Enter the source network mask.
Enter the source port number.
Enter the destination IP address.
Enter here the destination netmask.
Enter the destination port number.
Select the permitted protocols.
0. Back to ... Back to the higher-level menu
1. tcp
The TCP protocol is permitted.
2. udp
The UDP protocol is permitted.
3. tcp & udp
Both protocols are permitted.
Select the permitted interfaces.
0. Back to ... Back to the higher-level menu
1. all
All interfaces are permitted.
2. VPN
The VPN interface is permitted.
3. WAN
The WAN interface is permitted.
4. X1
The X1 interface is permitted.
5. X2
The X2 interface is permitted.
Enable or disable the filter.
0. Back to ... Back to the higher-level menu
1. on
The filter is enabled.
2. off
The filter is disabled.
To apply the changes for the selected filter entry,
choose this menu item.
To delete the selected filter entry, choose this menu
item.
Commissioning 189
Manual