Table 227: Run Led Diagnostics - E!Runtime - WAGO 750-8207 Manual

322 Diagnostics
The following indications apply to the e!RUNTIME runtime system:
Table 227: RUN LED Diagnostics – e!RUNTIME
Status
Green
Green flashing
Red
Green/red
flashing
Red,
goes out briefly
Red,
goes out longer
Red, flashing
Orange/green
flashing
Orange
OFF
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Applications loaded
and all in the "RUN"
status
No application and
now boot project
loaded
Applications loaded
and all in the "STOP"
status
At least one
application in the
"RUN" status and one
in the "STOP" status
Warm start reset
completed
Cold start reset
completed
At least one
application after in the
"STOP" status after
exception (e.g.,
memory access error)
Load above threshold
value 1
Runtime system in
debug state
(breakpoint, single
step, individual cycle)
No runtime system
loaded
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Remedy
---
Load an application or boot project.
Set the mode selector switch to "RUN" to
start the application.
Start the stopped application.
---
---
Start the application with a reset via the
mode selector switch or in the connected
IDE.
If the application cannot be started,
restart the controller.
Contact WAGO Support if the error
occurs again.
Try to reduce the load on the system:
- Change the CODESYS program.
- End any fieldbus communication that
is not essential, or reconfigure the
fieldbuses.
- Remove any non-critical tasks from
the RT area.
- Select a longer cycle time for IEC
tasks.
Resume the application in the connected
IDE with single step or start.
Remove the breakpoint if necessary.
If the connection has been interrupted,
set the mode selector switch to "STOP"
and then back to "RUN" to enable the
application to continue
Enable a runtime system, e.g., via the
WBM.