Configuration Of Serial Interface Rs232" Page; Serial Interface Assigned To" Group; Assign Owner Of Serial Interface (Active After Next Controller Reboot)" Group; Table 69: Wbm "Configuration Of Serial Interface Rs232" Page - "Assign Owner - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
</dg_
7.8.1.16

"Configuration of Serial Interface RS232" Page

The settings for the serial interface are shown on the "Configuration of Serial
Interface RS232" page.

7.8.1.16.1 "Serial Interface Assigned to" Group

The application that the serial interface is currently assigned to is displayed.
7.8.1.16.2 "Assign Owner of Serial Interface (Active after Next Controller
Reboot)" Group
You can specify the application that the serial interface is assigned to after the
next controller reboot.
Table 69: WBM "Configuration of Serial Interface RS232" Page – "Assign Owner of Serial Interface"
Group
Parameters
®
Linux Console
Unassigned (usage by
applications, libraries,
CODESYS)
Remove RS-485 devices before switching to "Linux Console"!
Connected RS-485 devices can be damaged when switching to "Linux Console".
Remove these devices before switching!
Click [Change Owner] to apply the change. The change only takes effect after
restarting the controller. For this purpose, use the WBM reboot function. Do not
shut down the controller too early!
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Specify that the serial interface is assigned to the
®
Linux console.
Specify that the serial interface is not to be assigned
to any particular application and is available, so that
the CODESYS program, for example, can access it
via function blocks.
Commissioning 129
Manual