112 Commissioning
</dg_
7.8.1.8
"TCP/IP Configuration" Page
The TCP/IP settings for the ETHERNET interfaces are shown on the "TCP/IP
configuration" page.
7.8.1.8.1 "IP Configuration (Xn)" Group(s)
If the switch is enabled, one group ("IP Configuration") is shown for both
connections.
If the switch is disabled, a separate group ("IP Configuration X1" / "IP
Configuration X2") is shown for each connection.
Table 50: WBM "TCP/IP Configuration" Page – "IP Configuration (Xn)" Group(s)
Parameters
Configuration Type
IP Address
Subnet Mask
Click [Submit] to apply changes. The changes are effective immediately.
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
750-8207 PFC200 CS 2ETH RS 3G
Explanation
Select a static or dynamic IP address.
Static IP
Static IP addressing
DHCP
Dynamic IP addressing
BootP
Dynamic IP addressing
Enter here a static IP address. This is enabled if
"Static IP" is enabled in the Configuration Type
field.
Enter the subnet mask. This is enabled if "Static IP"
is enabled in the Configuration Type field.
WAGO-I/O-SYSTEM 750