Package Server" > "Firmware Restore" Submenu; Firmware Restore" > "Select Package" Submenu; Table 160: "Package Server" > "Firmware Restore" Menu; Table 161: "Package Server" > "Firmware Restore" > "Select Package" Menu - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.4.8.4 "Package Server" > "Firmware Restore" Submenu
This submenu contains a selection option for the restore source drive.
In addition to the enabled partition, the current status is displayed.
Table 160: "Package Server" > "Firmware Restore" Menu
Menu Item
0. Back to ...
1. SD Card
2. Internal Flash
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
You are taken to the following submenu after making the selection.
7.8.4.8.5 "Firmware Restore" > "Select Package" Submenu
This submenu contains a selection option for the data to be restored.
Table 161: "Package Server" > "Firmware Restore" > "Select Package" Menu
Menu Item
0. Back to ...
1. PLC Runtime project
2. Settings
3. System
4. System + Setting
5. All
To make a selection, choose the appropriate menu item.
To return to the higher-level menu, press [Q].
The copy progress is displayed during the restore process.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
Back to the higher-level menu
The data is copied from the memory card.
The data is copied from the internal memory.
Explanation
Back to the higher-level menu
The PLC runtime project is loaded.
The controller settings are loaded.
The controller operating system is loaded.
The controller operating system and settings are
loaded.
All data is loaded.
Commissioning 195
Manual