Table 302: Description Of The Configuration Scripts For "Ntp - WAGO 750-8207 Manual

384 Appendix

Table 302: Description of the Configuration Scripts for "NTP"

Parameters Status Call
Configuration Data
State
Port
Time Server
Update Time
(seconds)
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
get_ntp_config
read
state
config_sntp
write
state=<Value>
get_ntp_config
read
port
config_sntp
write
port=<Value>
get_ntp_config
read
time-server-<N>
config_sntp
write time-server-
<N>=<Value>
get_ntp_config
read
update-time
config_sntp
write
update-time=<Value>
WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
Output/Input
Query the status of the NTP
server
Possible return values are:
- enabled
- disabled
Possible entries for <Value>:
- enabled
- disabled
Port number of the NTP server
Enter the port number for
<Value>.
Query the IP address of the time
server: N = 1 ... 4 for querying
one of 4 time servers.
Enter the IP address of 4 time
servers
<N> can be a value from 1 to 4.
<Value> is an IP address with the
format "Number. Number.
Number. Number."
Query the time in seconds
between two requests to the time
server.
Specify the time-server's query
cycle (in s) for <Value>.
Effecti
ve
Immedia
tely
Immedia
tely
Immedia
tely
Immedia
tely