Configuration Of User Filter" Page; User Filter" Group; User Filter N" Group; Table 60: Wbm "Configuration Of User Filter" Page - "User Filter" Group - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
7.8.1.12

"Configuration of User Filter" Page

7.8.1.12.1 "User Filter" Group

Table 60: WBM "Configuration of User Filter" Page – "User Filter" Group
Parameters
Count

7.8.1.12.2 "User Filter n" Group

Table 61: WBM "Configuration of User Filter" Page – "User Filter n" Group
Parameters
Source IP address
Source netmask
Source port
Destination IP address
Destination subnet mask
Destination port
Protocol
Input interface
Policy
Click the appropriate [Delete] button to remove a configured filter. The change is
effective immediately.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Explanation
The number of configured user filters is displayed.
Explanation
The source IP address for the respective filter entry
is displayed.
This displays the source network for the
corresponding filter entry.
The source port number for the respective filter entry
is displayed.
The destination IP address for the respective filter
entry is displayed.
The destination network mask for the respective
filter entry is displayed.
The designation port number for the respective filter
entry is displayed.
The permitted protocols for the respective filter is
displayed.
The permitted interfaces for the respective filter are
displayed.
Hier wird angezeigt, ob der Netzwerkteilnehmer
durch den Filter zugelassen oder ausgeschlossen
ist.
Commissioning 121
Manual