Figure 61: "Module Selection" Window; Figure 62: I/O Configurator With Defined I/O Modules - WAGO 750-8207 Manual

WAGO-I/O-SYSTEM 750
750-8207 PFC200 CS 2ETH RS 3G
10. You can select a module in the new "Module selection" window that then
appears.

Figure 61: "Module Selection" Window

11. You can change the position of an I/O module by marking it and then using
the arrow buttons at the right edge of the window to move it up or down.

Figure 62: I/O Configurator with Defined I/O Modules

12. Use [Import configuration from file] to add a configuration imported
previously using WAGO-I/O-CHECK.
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
Run-time System CODESYS 2.3 229
Manual